The manufacturer has specified an optimum level of the power steering fluid and it is assumed that when the fluid is hot, it will be at this level. If the fluid is cold, it may be at a lower level. The objective of this procedure is to show you how to check and adjust power steering fluid level as necessary.
Power steering systems can reach a working pressure of over 1,000 pounds per square inch or 6,700Kpa during operation. The objective of this procedure is to show you how to safely pressure test a power steering system. Always follow manufacturers or equipment manufacturers procedure when working on the system.
The objective of this procedure is to show you how to flush & bleed a power steering system. When circulating the fluid allow the engine to run for 10 to 15 minutes, turning the steering wheel from lock to lock several times to remove any air trapped in the system and circulate fluid through all parts of the system.
There are two types of drive belts: V-type and Serpentine type. The objective of this procedure is to show you how to inspect and manually adjust engine accessory drive belts.
The objective of this procedure is to show you how to check ball joints, lines and linkages according to manufacturer's recommendations. Ensure all rubber bellows or boots that are fitted to steering components are in good condition so that they do not allow contaminants to enter. Communicated any problems to your supervisor.
Wheel bearings are lubricated with grease, which also protects the metal from corrosion and helps conduct heat. The objective of this procedure is to show you how to clean, inspect, and repack non-driving wheel bearings.
